Clearances - Empire Comfort Systems DVP20MS Installation Instructions And Owner's Manual

In selecting a location for installation, it is necessary to provide ad-
equate accessibility clearances for servicing and proper operation.
Locating and Venting the Direct Vent Stove
Clearances: When facing the front of the direct vent stove the
minimum clearances to combustible construction (material) are
the following:
Top of appliance (ceiling)
Rear Wall
Side Wall
Heater Corners (45° angle) to Wall
Floor
Installation on Rugs and Tile
This appliance must be installed on a flat, solid, continuous surface
(e.g. wood, metal, concrete). This may be the floor, or it may be
raised up on a platform to enhance its visual impact. The continu-
ous surface may be covered with carpeting, vinyl, wood flooring
or other combustible material.
36" (915mm) TO
CEILING OR
HORIZONTAL
PROJECTION
ABOVE APPLIANCE
6" (153mm) TO
6" (153mm) 6" (153mm)
SIDEWALL
TO SIDE WALL TO SIDE WALL
42603-4-0421

CLEARANCES

36" (914.4 mm)
2" (50.8 mm)
6" (152.4 mm)
4" (101.6 mm)
0" (0 mm)
36" (915mm) TO CEILING OR 36" (915mm) TO CEILING OR
HORIZONTAL PROJECTION HORIZONTAL PROJECTION
ABOVE APPLIANCE ABOVE APPLIANCE
6" (153mm) TO
6" (153mm) TO 6" (153mm) TO
COMBUSTIBLE
COMBUSTIBLE COMBUSTIBLE
MATERIAL MATERIAL
MATERIAL
Figure 2
4" (102mm) HEATER CORNERS TO SIDEWALL
4" (102mm) HEATER CORNERS TO SIDE WALL 4" (102mm) HEATER CORNERS TO SIDE WALL
NOTE: HEATER
INSTALLED
AT 45° ANGLE
IN CORNER
NOTE: HEATER INSTALLED AT 45° ANGLE IN CORNER NOTE: HEATER INSTALLED AT 45° ANGLE IN CORNER
2" (51mm) TO COMBUSTIBLE MATERIAL
2" (51mm) TO COMBUSTIBLE MATERIAL 2" (51mm) TO COMBUSTIBLE MATERIAL
10" DVP20 10" DVP20
(254mm) (254mm)
14" DVP30 14" DVP30
(355mm) (355mm)
4"
4" 4"
(102mm)
(102mm) (102mm)
Figure 3
Figure 4
Page 9