Component Identification
Other Features
Foot Switch
The foot switch is used to initiate a PosiDot cycle when
operating in SHOT Mode. The foot switch is referred to
as a Start device in this manual. When the SHOT Mode
is selected and the start device is pressed and released,
the PosiDot will cycle.
Customer Signal
This allows the controller to operate the PosiDot from a
remote device. The Customer Signal air ports are
located on the left side of the PosiDot Controls box.
START Port: When air is applied, the PosiDot will oper-
ate as if the foot switch is pressed and held.
DONE Port: When the PosiDot has completed the
cycle, the DONE Port will discharge a pulse of air.
10
313904B