3. Install guide rods.
4. Install drive assembly to the guides.
Micrometer PD44 shown
5. Make sure the air inlet ports are pointed towards the
front plate and attach the front plate to the serial
number side of the metering body.
6. Install the cap head screws to the back plate.
313904B
Guide Rods
Cap Screws
7. Attach the metering rod to the material rod retaining
plate.
8. Slide the material rod retaining plate to the locked
position.
Retaining Plate
9. Install the back plate and cap screws.
Cap Screws
Rebuild
Back Plate
21