Table of Contents
Advertisement
D. Covers Removal For Servicing
Control Compartment Access Door
• Lift the lower door up and out to access the gas controls.
Trim Door and Glass Door
• Lift the front trim door up and out away from the appliance
side surrounds. Replace the door when servicing is
complete.
• Noting carefully how the brackets fit on the glass, release
the two spring latches at the top and two at the bottom
of the glass door. Carefully lift the glass up and out away
from the appliance. See Figure 9.6.
Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 9.6).
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 9.6 Fixed Glass Assembly
Heat & Glo • 350TSI-P-CEM • 2033-973 Rev. G • 4/17
E. Components Removal For Servicing
Pilot Assembly/Ignition System
1. Remove the media from the base pan.
2. Locate the pilot hood. Remove the screw located on
the right side of the pilot hood. Then separate the pilot
hood from the pilot bracket. See Figure 9.7.
3. Remove the screws securing the base pan to the burner.
4. Locate the pilot. Remove the screw that holds the pilot
to the pilot bracket. See Figure 9.7. Carefully pull
pilot up and out of the pilot bracket.
5. Remove the burner assembly by removing the screw
holding the burner down. Screw is located on the left
side of the burner assembly. Slide burner assembly
away from the burner orifice.
PILOT SCREW
Figure 9.7
PILOT HOOD
SCREW
39
Advertisement
Table of Contents
