Advertisement

CAUTION! Risk of Fire! DO NOT store instruction manuals inside fireplace cavity.
High temperatures could cause a fire.
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
Contact your Dealer with questions regarding installation, operation or service.
NOTICE: DO NOT discard this manual!
Models:
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
DO NOT MODIFY THIS APPLIANCE.
Owner's Manual
Care and Operation
Ref No GMK10533
AS/NZS 5263.1.3
Heat & Glo • I30X-N-AU, I30X-P-AU Owner's Manual • 2541-981 Rev. B • 1/19
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
• DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
- If you cannot reach your gas supplier, call
the fire department.
• Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the I30X-N-AU and is the answer not in the manual?

Questions and answers

Summary of Contents for Heat & Glo I30X-N-AU

  • Page 1 DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. DO NOT MODIFY THIS APPLIANCE. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 2: Welcome

    Maximum Nominal Gas Consumption..............MJ/h Electrical Rating..................240V 50hz 1A SAMPLE Type of Gas Model Number Serial Number Model: Gas Type: Seri a l : MADE IN USA XXXX-XXX Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 3: Table Of Contents

    C. Contact Information ......32  = Contains updated information. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 4: Limited Lifetime Warranty

    Exclusion, and Limitations listed Igniters, Electronic Components, and Glass 2 years Factory-installed fans Molded refractory panels 3 years Firepots and burnpots 2000-645E (11-17) Page 1 of 3 Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 5 HHT (8) modification of the appliance not expressly authorized and approved by HHT in writing; and/or (9) interrup- tions or fluctuations of electrical power supply to the appliance. 2000-645E (11-17) Page 2 of 3 Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 6 444 Swan Street 277 Lord Street 55 Marickville Rd. Richmond 3121 East Perth 6000 Marickville 2204 (03) 9429-5573 (08) 9228-2600 (02) 9505-8505 2000-645E (11-17) Page 3 of 3 Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 7: Product Specific Information

    * The allowable Outlet (Manifold) Gas Pressure ranges are: Natural Gas 0.63 - .95 kPa (0.76 kPa nominal) and Propane, ULPG 2.37 - 2.61 kPa (2.40 kPa nominal). Certification testing setpoint values are shown. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 8: Important Safety And Operating Information

    • Install a switch lock or a wall/remote control with child protection lockout feature. • Keep remote controls out of reach of children. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 9: General Operating Parts

    APPLIANCE SURROUND these conditions. For additional finishing guidelines, see Section 8 Installation Manual. Figure 3.3 Good Faith Wall Surface Temperatures Above Appliance Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 10 Sugges ons on how to further reduce TV temperatures: Increase “A” dimension. Increase “C” dimension, however, increasing “B” dimension beyond maximum recommended typically results in higher temperatures. Figure 3.4 Good Faith TV Guidelines Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 11: Before Lighting Appliance

    • Verify collar slide plate screw is attached see Figure 3.5. BE SURE SLIDE PLATE SCREW IS FULLY TIGHTENED. Figure 3.5 Collar slide plate Screw Detail Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 12: Lighting Instructions (Ipi)

    Propane Installation code, CSA B149.1. P65Warnings.ca.gov. For additional information on operating your Keep burner and control compartment clean. See installation and operating instructions accompanying appliance. refer to www.hearthnhome.com. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 13: Appliance Break-In

    NOTICE! Open windows for air circulation during fire- Figure 3.6 Glass Seal Plate place break-in. • Some people may be sensitive to smoke and odors. • Smoke detectors may activate. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 14: Heat Management

    See Figure 3.9. Check to make sure the ide exposure. ignition module switch is NOT in the “ON” position. • Resume normal operation with the RC300AU. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 15: Control Module Operation

    LOCK-OUT mode. Contact your dealer for service • Set the module selector switch to ON or REMOTE if this occurs. position. • Start the appliance. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 16 OFF function of the appliance. Follow instructions included with the installed control. If desired, a wall switch may be installed to control the ON/OFF function of the appliance. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 17: Remote Control Operation

    To prevent unintended operation when not using your fire- for compliance could void the user’s authority to operate place for an extended period of time (summer months, the equipment. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 18 The memory will be cleared. Note that the RC300AU will not be programmed if it’s in STANDBY mode. Press the ON/OFF button twice to switch to IDLE mode. Figure 3.13 Mounted Remote Control Housing Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 19 Use the SELECT button to select the current Select feature. Menu Menu Use the UP and DOWN arrows to toggle through the menu functions and value selec- Select Select tions in the submenus. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 20 • Press and hold the MENU and UP arrow buttons simul- taneously for 4 seconds to enable or disable the child lock feature. NOTICE: No functions will be usable until child lock feature is disabled. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 21 At control module, turn off fireplace by sliding the ON/OFF/ Remote control or control REMOTE switch to OFF. Warning! Risk of Burns! Fireplace is module failure hot. Use caution when accessing module. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 22: Maintenance And Service

    CAUTION! Risk of Burns! The fireplace should be turned off and cooled before servicing. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 23 Verify top latches are fully engaged and then fasten the two bottom latches using the supplied multi-purpose tool. • Reinstall door or decorative front. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 24 COMPONENT TRAY WITH HEAT SHIELD Figure 4.4 Component Tray Access CAUTION: Be sure to reinstall the component heat shield before firing the appliance. Components will overheat. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 25: Maintenance Tasks - Qualified Service Technician

    • Verify that the collar slide plate screw is installed. See Figure 3.5. • Remove all foreign objects. • Verify unobstructed air circulation. • Ensure no wire connections become disengaged. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 26 • Verify that there is not a short in flame sense circuit by checking continuity between pilot hood and flame sensing rod. Replace pilot as necessary. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 27: Frequently Asked Questions And Troubleshooting

    (4 AA cell batteries required). Refer to Section 3.I for more details. Contact your dealer for additional information regarding operation and troubleshooting. Visit www.heatnglo.com to locate a dealer. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 28: Reference Materials

    Contact your dealer or Hearth & Home Technologies if the barrier is not present or help is needed to properly install one. For more information refer to the instructions supplied with your decorative front. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 29: Service Parts

    Hearth Refractory (Not for use with BRICK-MI30-TR/BRICK-MI30-HB) SRV2542-704 Seal, Glass Frame 2532-122 GLA-2532 Glass Door Assembly Power Cord 2222-374 Blower 2264-500A Additional service part numbers appear on following page. 2/19 Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 30 Wire Tray 21.7 Tray, Component 2534-170 21.8 Wire Harness 2166-304 21.9 Jumper Wire SRV2187-198 21.10 AUX300, CE 2166-340 Additional service part numbers appear on following page. Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 31 593-526 Regulator NG NGK-DXV-50 Regulator Butane/Propane SRVLPK-DXV-50 **Fuse for battery pack can be sourced locally, not a warranty item. Specs are 250v, 1A fuse, 3/4” long Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...
  • Page 32: Contact Information

    6053165, 6145502, 6374822, 6484712, 6601579, 6769426, 6863064, 7077122, 7074035, 7098269, 7258116, 7322819, 7470729, 7726300, 8147240, 9625149 or other U.S. and foreign patents pending. 2000-945D Printed in U.S.A. - Copyright 2018 Heat & Glo • I30X-N-AU, I30X-P-AU Owner’s Manual • 2541-981 Rev. B • 1/19...

This manual is also suitable for:

I30x-p-au

Table of Contents