Programming Cables - oticon More Pocket Manual

Programming cables

Use FittingLINK 3.0/Noahlink wireless programmer to wirelessly connect to the
hearing aids (remember to insert a battery in the hearing aid).
The following wired programming can also be used: Oticon programming cable #3
or HI‑PRO #3 Left: 214463 Right: 214372
Alternative NOAHlink programming cable #2 (50 cm). Left: 384‑20‑023‑01 Right:
384‑20‑022‑00.
miniRITE and miniRITE T*
(Opn S, Opn, Alta Pro, Alta1 Pro, Alta2 Pro, Agil Pro)
Use FlexConnect 390‑01‑180‑05 (See lower right corner for image)
Step 1:
Insert a new battery. Do not close
the battery drawer.
Step 2: Insert the gold end of FlexConnect
into the space right above the
battery drawer hinge. Make sure
the black dot on FlexConnect is
facing away from the battery
drawer and push until the black
dot touches the hearing aid. Close
the battery drawer.
miniRITE R*
(Opn S)
Use FlexConnect 390‑01‑180‑05 (See lower right corner for image)
Step 1: Open the battery drawer with
dedicated tool.
Step 2:
Insert the gold end of FlexConnect.
Follow description for miniRITE T
for how to insert. Close the battery
drawer before programming. Press
and hold the lower part of the
push button for approx. 2 seconds.
Release the button and wait until
the hearing aid LED turns GREEN.
The hearing aid is now turned ON.
96
1.
2.
Programming cables (cont'd)
BTE, BTE PP, BTE SP, BTE UP
(Opn S, Opn, Xceed SP, Xceed UP, Alta2 Pro)
Insert the programming cable in
the bottom of the hearing aid
(direction connection).
ITC, ITE HS, ITE FS*
(Opn, Alta Pro, Alta2 Pro)
Use FlexConnect Mini 117468
(See below image)
IIC, CIC*
(Opn, Alta2 Pro)
Use Programming Adapter
Mini 164237
1.
FlexConnect
(miniRITE, miniRITE T, miniRITE R)
No battery
1. 2.
2. No battery
FlexConnect Mini
(ITC, ITE HS, ITE FS)
97