Table of Contents
Advertisement
Instruments which have never been programmed must be
assigned to the correct side – left and right – in Genie.
use a BeeP test as follows:
1
20
OticOn chili FITTInG GuIde
To identify the instrument place it in the middle of the
neck loop and click BeeP. The instrument will beep for
6 seconds.
While the instrument is beeping, remove it from
neARcom and listen to it.
If the instrument does not beep, return it to the middle of
1
the neck loop, click Change side
and click the same BeeP.
Listen to the instrument again.
Click Continue and proceed with the programming.
Programming chili
Structure in genie
1
2
3
4
5
6
the Organizer – horizontal navigation
Main programming steps
1. Client: Appears only when running Genie outside nOAH.
2. Counselling: Appears only if Gateway has been installed.
3. Family: Selection of all hearing instrument families.
4. Selection: Select instrument styles and Streamer
5. Fitting: Verifying and fine tuning of settings.
6. end Fitting: Verify and set user operated buttons and link
Streamer(s).
task Pane – Vertical navigation
In each organizer step there is a Task Pane that gives access
to tools and links related to where you are in the fitting
process.
4
21
Advertisement
Table of Contents
