Accessories; Shop Tools; Warehouse & Dock products; Hand Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.
10. The air tool must be properly lubricated before operating. Do not use this tool for other than its intended use. If used for other purposes, JET disclaims 11. Never start a percussion type air tool (chipper, any real or implied warranty and holds itself breaker, buster, etc.) without securing the...
Page 4
33. Do not lubricate the tool with combustible off the trigger, before connecting to air supply. liquids, such as kerosene, diesel or jet fuel. 24. Remove adjusting keys and wrenches before 34. Do not dispose of this tool with normal turning on tool.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
Set air pressure to 90 psi. Any missing parts or damage should be reported ® immediately to your JET distributor. Do not use a IMPORTANT: Connecting a quick-change damaged tool. Read this instruction manual...
Page 8
Lubrication Information Use a light oil containing rust inhibitors, such as SAE #10. Many JET air tools have integral oil If the air tool is not performing according to reservoirs, which should be kept filled when in-line specifications, the following are among the most oilers are not used.
Page 9
Figure 2 Recommended arrangement of air piping and air line system ...
Page 10
Troubleshooting JAT-720 High-Speed Sander Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
Replacement parts Replacements are listed on the following pages. To order parts or reach our service department, call 1-800- 274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve you quickly and accurately. ...
Page 13
#505720, JAT-720, Dual Action Sander – parts list Index Part No. Description Index Part No. Description JAT720-01 Housing cover 25 JAT720-25 Ball JAT720-02 Motor housing with handle 26 JAT720-26 Rotor JAT720-03 Throttle lever 27 JAT720-27 Rotor vane JAT720-04 Hinge screw...
Page 14
This page intentionally left blank. JAT-720 Dual Action Sander ...