Table of Contents
Advertisement
6.7
Securing the burner to the boiler
Provide an adequate lifting system.
Be careful as some drops of fuel may leak out
during this phase.
To separate the burner from the cast iron blast tube, proceed as
follows:
Remove the cover 1), the split pin and pin 2), the nuts 3) and
the screws 4).
Pull out the blast tube from the burner by approx. 100÷120
mm and release the driving fork of the head 6) by removing
the split pins 5).
At this point, it is possible to fully pull out the blast tube from
the pins 7).
Fix the blast tube to the boiler by inserting the insulating seal
8) in-between.
After fitting the selected nozzle, fit the burner on the pins 7)
leaving it open by approx. 100 ÷ 120 mm.
Refit the fork 6) fixing it with the split pins 5).
Completely close the burner fastening it with screws 4), fit
the nuts 3), the pin and split pin 2).
6.8
Nozzle assembly
At this installation stage the burner is still separated from the blast
tube; therefore it is possible to fit the nozzle with a 24mm wrench
3)(Fig. 13) after removing the screws 1) and the turbulator 2). Do
not use any sealing products such as: gaskets, tape or sealants.
Be careful to avoid damaging the nozzle sealing seat.
Do not use any sealing products such as:
gaskets, tape or sealants.
Be careful to avoid damaging the nozzle
sealing seat.
ATTENTION
The nozzle must be screwed into place tightly
but not to the maximum torque value
provided by the wrench.
6.9
Electrodes adjustment
Check
that
correctly, as in Fig. 14, complying with the
dimensions indicated.
ATTENTION
20170392
the
electrodes
are
positioned
Installation
2
1
The seal between burner and boiler must be
airtight.
ATTENTION
5
± 0.2
18
GB
3
7
6
4
5
mm
D8677
5
± 0.2
8
D2590
100÷120mm
Fig. 12
20119193
Fig. 13
mm
Fig. 14
Advertisement
Table of Contents
