Optical Drive - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Remove the optical drive blank
6.
To replace the component, reverse the removal procedure.

Optical drive

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
CAUTION: To prevent improper cooling and thermal damage, do not operate the chassis
unless all bays are populated with a component or a blank.
To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 27).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
5.
("Remove the security bezel
("Access panel" on page 37).
(optional)" on page 26).
Removal and replacement procedures 45