Drain Installation - Santa Fe COMPACT70 Installation & Operation Instructions

Drain Installation

The Santa Fe Compact70 generates condensate.
Place a secondary drain pan under the dehumidifier if it is suspended above a finished area or above an area where wa-
ter leakage could cause damage.
A drain trap is required for the dehumidifier to run properly. Install a 3/4" threaded male NPT adapter to the drain or
drain pan if one is being used. Install a drain pipe assembly utilizing 3/4" PVC pipe to transport the condensate to a
drain. Pitch of drain should be 1" per 10'.
An optional condensate pump kit is available for use with the Santa Fe Compact70 and may be installed if lift is required
to dispose of condensate. Condensate is automatically pumped to a remote location when the water level in the pump's
reservoir rises to close the float switch.
The pump also contains a safety float switch. The white leads from this switch extend from beneath the pump cover. This
switch should be installed in series with the field wire that connects to the common lead from the Santa Fe Compact70 to
the control panel. If the pump fails, this switch opens the common control circuit and stops water production before the
reservoir overflows. Contact a qualified electrician to install the safety float switch to the Santa Fe Compact70 dehumidifier.
Note: An optional condensate pump kit can be purchased from a local dealer or online.
The Santa Fe Compact70 requires a drain trap. Creating a drain
trap allows a small amount of water to build up in the trap area
of the clear hose. This prevents air from back flowing through
the hose and into the dehumidifier; essentially causing the unit
to backflow water out of the corners of the machine. Position the
trap in the hose approximately 8"-10" from the dehumidifier and
make sure the highest point of the trap is still at least 2" below
the black drain port adapter on the dehumidifier. If the highest
point of the trap is above the drain port, water will back flow into
the dehumidifier. Check the hose regularly to ensure water is
draining properly.
Drain Installation
Front View
Secondary Drain Pan
(Optional)
8
Santa Fe Compact70 Installation & Operation Instructions
Standard Loop
Floor Bend
PVC materials available from your local hardware store.
For additional information on how to create a
proper trap, see our instructional video at:
www.Santa-Fe-Products.com\drain-trap\
Use care to keep the hose as flat to the floor as
possible after your trap is in place. Be sure the hose is
not kinked or otherwise restricted so water can pass
through the hose freely. Improper installation of the
drain hose may result in water leakage.
If the Santa Fe Compact70 is located too far from the floor
Drain Port
drain and the provided hose does not reach, you may use
a 1/2 PVC rigid pipe that will fit inside the 3/4 hose as a
means to extend the drain line. Rigid PVC tubing is readily
available from your local hardware store. Be sure the
extension is at a down-word slope to the drain.
An optional condensate pump kit may be installed if
Drain Trap
lift is required to remove condensate. To order,
contact your local dealer or visit our website at
www.santa-fe-products.com. You may also reach
us by phone at (800) 533-7533.
Pretzel Loop
PVC Trap
Santa-Fe-Products.com | 800.533.7533