Disassembly Instructions - Mitsubishi Electric MSZ-FH25VE2-E1 Service Manual

11

DISASSEMBLY INSTRUCTIONS

DISASSEMBLY INSTRUCTIONS
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
11-1. MSZ-FH25VE
MSZ-FH25VE2 MSZ-FH35VE2 MSZ-FH50VE2
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vanes.
Removal procedure
Unlock the upper and lower vanes as shown
in using a thin instrument.
Then, remove the horizontal vanes in the
direction of .
Unlock
(2) Remove the front panel. Remove the screw caps of
the under panel. Remove the screws of the under
panel.
(3) Pull out the right top corner of the right panel and
remove the right panel.
(4) Pull out the left bottom corner of the left panel and
remove the left panel.
(5) Unhook the lower part
remove the under panel.
OBH623D
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MSZ-FH35VE MSZ-FH50VE
Upper and
lower vanes
of the under panel and
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Photo 1
Front panel
Horizontal vanes
Photo 2
Left panel
Screws of the panels
Screws of the under panel
38
Horizontal vanes
Right panel
Under panel