Mitsubishi Electric MSZ-FH25VE2-E1 Service Manual page 29

B Check of remote controller and indoor electronic control P.C. board
Check if the remote controller is exclusive for this air conditioner.
Press OPERATE/STOP (ON/OFF)
(MSZ-FH25/35/50VE)/STOP/
OPERATE (OFF/ON) (MSZ-
FH25/35/50VE2) button on the
remote controller.
Is LCD display on the remote
controller visible?
Yes
Remove the batteries, then set them
back and press RESET button.
(Refer to 10-1.4.)
Check if the unit operates with the
remote controller.
Does the unit operate with the
remote controller?
Yes
OK
OBH623D
Replace the batteries. (Refer to 10-1.4.)
No
(Not clear)
Assign a number of remote controller.
(Refer to 8-2.)
No Check if the unit operates with the
remote controller.
Does the unit operate with
the remote controller?
Yes
OK
Measure the voltage between receiver P.C. board connector CN301 No.1(-) and No.3(+)
when the remote controller button is pressed.
Is the voltage approximately 4 VDC - 5 VDC?
Replace the receiver P.C. board.
1 Look at the image of the signal transmitting section of
the remote controller through the monitor of a digital
camera or a camera phone. It is normal if the LED of
the signal transmitting section lights up when the OP-
ERATE/STOP (ON/OFF) (MSZ-FH25/35/50VE)/STOP/
OPERATE (OFF/ON) (MSZ-FH25/35/50VE2) button on
the remote controller is pressed. However, it may be dif-
fi cult to see the illuminated LED of the signal transmit-
ting section with a smartphone camera.
2 If the inverter fl uorescent light is turned on when the
room is cool, the unit may have diffi culty receiving the
signal from the remote controller or may not be able to
operate with it; if the inverter fl uorescent light is turned
on when the room is warm, the unit may be able to
operate with the remote controller.
Turn ON a radio to AM and press
OPERATE/STOP (ON/OFF) (MSZ-
FH25/35/50VE)/STOP/OPERATE
No
(OFF/ON) (MSZ-FH25/35/50VE2)
button on the remote controller.
Is noise heard from radio?
Yes
Are there any fl uorescent lights
of inverter or rapid-start type
within the range of 1 m?
No
Yes
No
29
1
Replace the remote controller.
No
• Reinstall the unit away from lights.
• Attach a fi lter on receiving part.
Yes
2
Replace the indoor electronic
control P.C. board.