Sony BRC-H800 Operating Instructions Manual page 41

TALLY MODE
This allows you to set up the Tally lamps on the front
and back of the camera. Choose from HIGH, LOW, and
OFF.
HIGH: When the Tally lamp is turned on, the one on the
front of the camera comes on bright.
LOW: When the Tally lamp is turned on, the one on the
front of the camera comes on dim.
OFF: When the Tally-lamp-on command is issued, the
Tally lamps on the front and back of the camera
do not come on.
Note
When TALLY MODE is turned off, both the front and
back Tally lamps do not come on.
The brightness of the Tally lamp on the back of the
camera cannot be adjusted. It comes on at the same
brightness for LOW and HIGH.
TELE CONVERT MODE
You can shoot using 2× magnification.
OFF: Does not use the magnification function.
2x: Uses the magnification function.
Notes
• Enabled only when SYSTEM SELECT is set to
1920×1080.
• The angle of view when TELE CONVERT MODE is
set to 2x is narrower than when set to OFF.
PRESET MODE
Sets preset mode.
MODE1: Recall all saved settings when recalling a
preset.
MODE2: Recall only the pan, tilt, zoom, and focus
positions when recalling a preset.
TRACE: Select to control operation using the PTZ
TRACE function, without displaying the menu.
P/T SPEED TYPE
Selects the range and number of resolution steps for the
pan/tilt operation speed.
NORMAL: Assigns speeds in the NORMAL speed
range over 24 steps.
Extd. RANGE: Extends the speed range by having
lower minimum speed than NORMAL range.
The speed can be set over 24 steps.
Extd. STEP: Extends the speed range by having slower
minimum speed than NORMAL range with
higher number of resolution steps. The speed can
be set over 50 steps.
Note
For pan/tilt operation using when P/T SPEED TYPE is
set to Extd. STEP, use a remote controller that supports
this speed type. Correct operation may not occur if
using a remote controller that does not support this
speed type.
P/T SLOW MODE
Set to ON to reduce the speed of each step setting for
slower pan/tilt operation. This is enabled when P/T
SPEED TYPE is set to NORMAL or Extd. RANGE.
ZOOM SPEED TYPE
Selects the range for the operating speed of zoom
operation.
NORMAL: Operates in the NORMAL speed range.
Extd. RANGE: Operates in the speed range with lower
minimum speed setting than NORMAL range.
VERSION
This indicates the version of the firmware installed on
the camera.
41