Canon HR10 Instruction Manual page 25

i pl
.... ii il)i
finger, and the _ button
with your thumb.
Using the Wireless Controller
First, insert the supplied lithium button
battery CR2025 into the wireless
controller.
Tab
1
Press the tab in the direction of
the arrow and pull out the battery
holder.
2
Place the lithium button battery
with the + side facing up.
3 Insert the battery holder.
situated under strong light sources or
direct sunlight.
• If the wireless controller does not work,
check that [WL.REMOTE] is not set to
[_ OFF ,_/] (L_ 52). Otherwise,
replace the battery.
Whenyoumountthe camcorder ona
tripod
Do not leave the viewfinder
exposed to direct sunlight
as it may melt (due to
concentration of the light by
the lens). Do not use tripods
with fastening screws
longer than 5.5 mm (0.2 in.).
Doing so may damage the camcorder.
Point the wireless controller at the
camcorder's remote sensor when
you press the buttons.
_ NOTES
• The wireless controller rnay not work
properly when the remote sensor is
25