Setting The Ironing Temperature; Steam Ironing - Maxwell MW-3003 B Manual Instruction

ENGLISH
glossy quickly should be ironed
strictly in one direction (along the
lines) with slight pressure.
• T o avoid appearance of glossy spots
on the synthetic and silk fabrics, iron
them back-side.
SETTING THE IRONING
TEMPERATURE
• P lace the iron on the base (8).
• I nsert the power plug into the outlet.
• S et the temperature regulator (11)
to the required ironing temperature:
"•", "••", "•••" or "max" (depend-
ing on the type of fabric), the (9) indi-
cator will light up.
• W hen the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
Note: While steam ironing set the
temperature «•••» or «МАХ».
WATER SPRAYER
• Y ou can dampen the fabric by press-
ing the spray button (4) several times.
• M ake sure that there is enough water
in the water tank (10).
IRONING
• P lace the iron on the base (8).
• I nsert the power plug into the outlet.
• S et the temperature regulator (11)
to the required ironing temperature:
"•", "••", "•••" or "max" (depend-
ing on the type of fabric), the (9) indi-
cator will light up.
• W hen the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
• A fter you finish ironing set the (11)
MW-3003_Newt.indd 12
regulator to the "min" position.
• P ull the plug out of the socket and let
the iron cool down completely.

STEAM IRONING

For steam ironing set the temperature
regulator to «•••» or «МаХ».
• P lace the iron on the base (8).
• I nsert the power plug into the outlet.
• M ake sure that there is enough water
in the water tank (10).
• S et the temperature regulator (13)
to the required ironing temperature:
"•••" or "max", the (9) indicator will
light up.
• W hen the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
• T urn the steam supply regulator (3) to
set the intensity of steaming, steam
will start outgoing from the openings
of the sole (13).
• A fter you finish ironing set the (11)
regulator to the "min" position and
the steam supply regulator (3) to the
low position.
• P ull the plug out of the socket and let
the iron cool down completely.
ATTENTION!
If during the operation steam is not con-
stantly supplied, check whether the tem-
perature regulator (11) is set properly.
ADDITIONAL STEAM RELEASE
Additional steam release function is
useful when ironing folds and can only
be used at high ironing temperatures
(when the iron temperature regulator
(11) is set to "•••" or "max").
• W hen the additional steam release
button (5) is pressed, steam will be
12
22.08.2013 12:07:41