Toro 2000 Series Operator's Manual page 39

3. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it
Changing the Engine Oil
Note:
Dispose of the used oil at a recycling center.
1. Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
3. Disengage the blade-control switch (PTO) and
engage the parking brake.
4. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
5. Drain the oil from the engine
(Figure 42).
Figure 42
(Figure 43).
g235263
37
Figure 43
g027734