Connecting An Oximeter To The Reslink (Optional); Attaching An Oximeter To Your Finger - ResMed Reslink User Manual

58 RESLINK
I.
Ensure that the
You will need
2. Take off the module currently
the
3. Push the SS
and bottom latches
Note:
4. When attached, the SS
generator (F-3).

CONNECTING AN OXIMETER TO THE RESLINK (OPTIONAL)

Your clinician may have supplied an oximeter
oximeter to the RESLlNK allows collection
saturation and pulse
I.
Ensure that the sensor cable is properly
illustration D).
2. Insert
WARNING
Only the
•
Sensors are compatible with the Reslink. Connecting other oximeters may
cause personal injury or damage to the flow generator or the Reslink.
Check the oximeter cables and the oximeter sensor before use. If there is any
•
sign of damage or wear contact your equipment supplier.
There is a serial (9-pin) port at the back of some flow generators. Do not
•
connect the
oximeter.

ATTACHING AN OXIMETER TO YOUR FINGER

CAUTION
The oximeter sensor will not function properly if there is nail polish on your
fingernails.
Note:
ATTACHING THE NONIN 8000J ADULT
See section
Your clinician wi
6
flow
generator is p
to the
tum
generator b g.
flow a
onto the flow generator (F-
REsLINK
engage
The SB ResUnk does not have a locking lever.
REslJNK should frt closely onto
rate).
the into the
oximeter plug
NONIN
Model 3012 Pulse Oximeter and Models SOOOJ or SOOOAA
NONIN
Xpod connector into the serial port as it may damage the
Do not atta ch the oximeter unti l you
G on the illustration sheet
II
attached the
have
d
re off before
owe
power off at the wall ou
attached to the flow generator
with the
firmly flow
use with the RES LINK.
for
storage of oximetry data
and
connected to the Xpod
REslJNK oximeter port
ready to start therapy.
are
SENSOR
FLEX
to
sensor the adhesive side of the FlexiWrap.
SS
attaching
the
t
let.
(F-1) and
),
2 making sure that both
generator.
the the flow
back of
Connecting an
( oxyg
connector
(E-6).
RESLINK.
store it i n
the top
en
(see