ResMed Reslink User Manual page 18

Problem
The 'Successful
connection' message (see
8)
page
after power
Difficulty inserting the
SmartMedia card into the
RESLINK.
A SmartMedia card is
inserted
UPGRADING, WAIT.
is not
The following Is displayed
on the LCD when a
SmartMedia card is Inserted
and the flow generator is
powered on:
CARD ERROR!
Res Link
During software
a blank screen is displayed flow
on the LCD.
14
Possible Cause
Reslink The RESLINK is not
attached to the flow
is not displaye d generator.
up.
Incompatible
generator.
Faulty
Incompatible memory card
used.
The SmartMedia card is
inserted incorrectly.
Software upgrade not
but required.
displayed.
SmartMedia card cannot be Power the flow
accesse�it may be
partially
Alternatively, the gold
contacts could be dirty.
1/4 The SmartMedia Card may
be damaged.
loss of power supply to the
upgrade,
securely
flow
RESLINK.
inserted.
generator.
Solution
Power the flow generator off.
Ensure that the RESLINK
connected to the flow generator.
Also ensure that the lever
back of
the RESLINK is in the
position. Power the flow
generator back on.
For the S8 RESLINK make sure that
the top and bottom latches are
secured properly.
The RESLINK and S8 RESLINK are
compatible for use with certain
ResMed flow generators
"Compatible flow generators"
18.
page
Contact your equipment supplier.
Ensure that a SmartMedia
obtained from ResMed
used.
See "'Inserting the Card"
page5.
OK.
This is Continue with
generator
Remove and then re-insert the
SmartMedia card.
Contact your equipment supplier.
Power the flow generator
insert the SmartMedia card.
Check the power supply
flow generator. Power the flow
generator back on. See ''Using the
7.
Reslink" on page
is securely
at the
lock
only. See
on
card,
only, is
on
setup.
off.
off. Re­
to the