ResMed Reslink User Manual page 20

Problem
The message on the LCD
alternates between the
RESLINK
message,
and the message to
indicate
been removed.
The following message is
displayed on the LCD:
NO OXIMETER
Res Link
The following message is
displayed on the LCD:
The following message is
displayed on the LCD:
READ-ONLY
Res Link
The following message is
displayed on the LCD:
The following message is
displayed on the LCD:
Difficulty
the RESLINK
generator.
Difficulty disconnecting
the S8 RESLINK from the
flow generator.
Note:
16
Possible Cause
SmartMedia card may be
damaged.
connected
RESLINK may be faulty.
that RESLINK has
Oximeter is not present
during the copying of
Summary Data to the
SmartMedia
2/4
The SmartMedia Card is full Contact your equipment supplier
and cannot store any more
data
SmartMedia Card is write
protected
CARD!
1/4
The software on
itself is being upgraded,
using data
SmartMedia
RESLINK has been removed
from the flow
not attached correctly.
Res Link
Removed
disconnecting The RESLINK is locked in
from the flow place.
There is no locking device
on the S8
If you see a message not shown here, contact your equipment
Card.
.
.
the RESLINK This is OK. Wait for
on the
Card.
generator or
RESLINK.
Solution
If the message does not clear,
disconnect the RESLINK and
contact your equipment supplier
to get a new SmartMedia
Contact your equipment
If you are not intending
oximeter, this message is OK. If
you are intending to use an
oximeter, make sure that the
oximeter is plugged in correctly.
to get a new SmartMedia
Contact your equipment supplier
to get a new SmartMedia
approximatel y three minutes.
RESLINK should then start
operation.
Attach the RESLINK or S8
to the flow generator. Make
that it is properly attached.
Unlock the RESLINK. See
"Disconnecting the ResLink"
11.
page
See "58 ResLink" on page
supplier.
Card.
supplier.
to use an
Card.
Card.
normal
RESLINK
sure
on
11.