Safety Symbols - Gardner Denver L Series Original User And Service Manual

2.6

Safety Symbols

The safety symbols (hazard warning signs) can be used in the operating instructions and in the
environment around the compressor.
Safety Symbol Meaning
General hazard
Slip hazard
Component or system
under pressure
Do not operate with open
doors or loose clothing.
Do not breathe in the
compressed air from this
unit
Electrical voltage
System continues to run The compressor continues to run for at least 30 second after
Read and follow the
instructions for use
Bacterial contamination
hazard
Caution: hot liquid
Application / Behavior
Warning of a general hazard.
Follow the warning and proceed with the required caution
(e.g., protective clothing) and care.
Warning of a slip hazard.
Use caution when walking, stepping, or climbing.
Labeling of devices or areas in which the air pressure is
substantially higher than in the normal atmosphere.
Do not open devices or chambers until the pressure has been
equalized.
It is not permitted to run the compressor with open doors or
loose clothing, except for test runs. High sound pressure level,
risk of injury!
Normal operation requires the enclosure to be closed.
It is not permitted to use the compressed air produced by this
compressor for breathing. Indrawn materials can be dangerous
to health.
Do not use compressed air as breathing air.
Warning against dangerous electrical voltage.
Work on the electrical equipment of the compressor may be
done only by an electrician in accordance with electrical rules.
the stop button is pressed.
Do not open the compressor enclosure until the compressor
has stopped.
Before the machine is operated, the user (operator) must have
read and understood the instructions for use (manufacturer's
instructions for use).
Labeling of instructions to the user that additional information
can be found in the (manufacturer's) operating instructions.
Warning of the presence of Legionella in the cooling water in
an open-loop cooling water circuit
Continuous monitoring of the cooling water by maintenance
personnel.
Warning of hot oil or hot coolant.
Allow the compressor to cool before opening the fluid circuit
lines.
13-25-640 v00 Page 11