Gardner Denver L Series Original User And Service Manual page 36

Electrically connect the compressor
Figure 5-3 Electrical connection
1. Install a customer supply line cover.
2. Run the supply lines through the openings in the electrical enclosure (A).
3. Connect the supply lines; see Detail A and wiring diagram.
4.
Tighten the cable screws.
Variable speed units are supplied with terminal blocks to land incoming power conductors. Terminal
blocks are pre-wired to the line side of the Variable Frequency Drive for convenience. The final
installation is up to the discretion of the installer's certified electrical contractor and local electrical codes.
13-25-640 v00 Page 36