CNET CWR854 User Manual page 41

milliseconds after the port trigger action during which incoming requests will be accepted.
5. Choose Enable or Disable from the drop-down list for Session Chaining. This parameter
specifies whether or not dynamic sessions can be chained, allowing multi-level session
triggering.
6. If you chose Enable in Step 5, you may now choose Enable or Disable for Chaining on UDP.
If you chose Disable in Step 5, skip to Step 7.
7. Choose Enable or Disable from the drop-down list for Address Replacement. This
parameter specifies whether or not binary address replacement should be performed.
8. If you chose Enable in Step 7, you may now choose the Address Translation Type (TCP or
UDP). If you chose Disable in Step 7, skip to Step 9.
9. Choose Enable or Disable from the drop-down list for Multi Hosts. Enabling this parameter
allows a new session to be initiated from/to different remote hosts.
10. Click Apply to put your changes in effect, or click Cancel to undo your changes.
To delete a special application:
1. Enter 0 - 0 for Trigger Port Range.
.
2. Click Apply
41