Table of Contents
Advertisement
Operating Multiple Cameras
Before operating, you must assign the camera addresses
to the connected cameras. Then you can switch the
camera to be controlled simply by pressing the
corresponding CAMERA button.
To assign camera addresses
automatically
1
Turn on the power of all the connected cameras and
the remote controller.
Note
After turning on the power of the camera, wait more than
two minutes and turn on the power of the remote
controller. Otherwise, the connection may not be
recognized.
2
Hold down the RESET button and press the
POWER button on the remote controller.
The remote controller recognizes the connected
cameras and assigns them camera addresses 1 to 7
automatically in the connected order.
3
Press the POWER button on the remote controller
and check that the CAMERA buttons light.
The number of the lit CAMERA buttons indicates
how many cameras have the addresses assigned.
Now you can switch the camera you want to control
with the remote controller by pressing the
CAMERA button.
Note
The connection of the camera and the remote controller
is available for RS-422 connection only.
Therefore, the number of connected cameras that can be
controlled is up to 7.
48
Pan/Tilt and Zoom Operation
Pan/Tilt and Zoom
Operation
Panning and Tilting
PAN-TILT RESET
JOYSTICK
VALUE
LOCK
BLACK
PAN-TILT
ONE PUSH
POSITION
GROUP
LIGHT
RESET
AWB
KNOB
RESET
–
+
R
PRESET
GROUP
POSITION
MODE
BRIGHT
1
2
3
4
5
SHIFT
9
10
11
12
13
–
+
GROUP
B
SELECT
CAMERA
AUTO
FOCUS
AUTO
1
2
3
4
5
POWER
MANUAL
ONE PUSH
NEAR
FAR
AF
1
Press the CAMERA button corresponding to the
camera you want to operate.
2
Pan or tilt the camera using the joystick.
While checking the picture on the screen, incline
the joystick in the desired direction.
The panning/tilting speed changes according to the
angle at which you incline the joystick.
Release the joystick to stop panning/tilting.
To face the camera back to the front
Press the upper button on the joystick for 1 or 2 seconds.
Press for 1 or 2 seconds.
If you accidentally move the camera with
your hand
Press the PAN-TILT RESET button to perform the pan/
tilt reset action.
MENU
6
7
8
14
15
16
6
7
1
2
Advertisement
Table of Contents
