Sony SRG-300SEC User Manual page 30

Host name
Type the host name of the camera to be transmitted
to the DHCP server. This setting is valid only when
Obtain an IP address automatically (DHCP) is
selected.
Domain suffix
Type the domain suffix of the camera to be
transmitted to the DHCP server. This setting is valid
only when Obtain an IP address automatically
(DHCP) is selected.
Note
The domain suffix is sent to the DHCP server as
FQDN (Fully Qualified Domain Name)
information when Host name is set.
IPv6 setting
Configure the IPv6 network setting.
To obtain the IPv6 address automatically
Select Obtain IP address automatically.
The IP address, prefix length, default gateway are
assigned automatically.
Note
If you select Obtain IP address automatically, ask
the network administrator whether an IPv6 address
can be assigned.
This function is not available in a multi-prefix
environment. The transmission may not work
properly.
To specify the IPv6 address manually
Deselect Obtain IP address automatically. Type
the address in the IP address, Prefix length and
Default gateway boxes.
IP address
Type the IP address of the camera.
Prefix length
Type the prefix length value.
Default gateway
Type the default gateway.
Common setting
Configure the common setting for IPv4 and IPv6
network.
HTTP port number
Type the HTTP port number. Normally select 80.
30
Configuring the Network — Network Menu
MTU
Type the MTU value for the Ethernet port.
To obtain DNS server address
automatically
Select Obtain DNS server address automatically.
The Primary DNS server and Secondary DNS
server are assigned automatically.
Note
To obtain a DNS server address automatically, first
enable Obtain an IP address automatically
(DHCP) in the IPv4 setting, or Obtain IP address
automatically in the IPv6 setting.
Ask the network administrator whether a DNS
server address can be obtained automatically.
To specify the DNS server address
manually
Deselect Obtain DNS server address
automatically. Type the address in the Primary
DNS server and Secondary DNS server boxes.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
VISCA Interface
Select the connection to the remote controller.
When you use the RS-422 connector for the
connection, select Serial. When you use a network
cable for the connection to the LAN port of the
camera, select IP.
OK/Cancel
See "Buttons common to every menu" on page 19.