Table of Contents
Advertisement
High Pressure Hose
•
Screw the high pressure hose (clockwise) on the left of the unit at the bottom (Fig. 4). Pull back
the collar and insert o-ring post into the water outlet far enough so the collar can thread onto the
outlet threads until hand tight. Do not use pliers or vice grips to tighten. If it takes fewer than six or
so turns you have not properly tightened the high pressure hose fitting. It is easier to position the
power washer in front of you so to ensure that the threads are started correctly. Failure to properly
tighten the high pressure hose will result in the hose slipping or popping off immediately upon
turning the unit on. Do not worry about damage if this occurs - just reinstall and take extra care at
screwing on the high pressure hose fitting.
•
Connect the other end of the high pressure hose to the spray gun by inserting the brass metal tip
of the high pressure hose into the fitting just ahead of the trigger guard. It will lock into the spray
gun with a "click" (Fig. 5). Confirm the hose is locked into the spray gun by pulling slightly on the
hose. The hose is now securely attached to the spray gun.
•
To release the hose from the spray gun, press the button on the underside of the gun toward the
trigger guard. The hose will slide out from the connection (Fig. 6).
Fig. 4
Fig. 6
Fig.5
9
Advertisement
Table of Contents
