Microtek ArtixScanDI 7200S User Manual page 53

3. To remove the Separation Roller, hold
the roller and then take it out from the
assembly unit.
4. To install a new Separation Roller
onto the assembly unit, gently hold
both sides of the roller and insert two
flanges on the roller into the notches
of the assembly unit.
Please take note that two flanges on
the roller are designed in different
sizes. The left flange is wider than
the right one. Make sure that you
have put them at the correct side
before inserting them into the slots of
the assembly unit.
5. Close the cover of the Separation
Roller Assembly back. Then, push the
scanner cover back until you hear a
"click".
NOTE:
• The recommended replacement point for the Separation Roller is
approximately 150,000 scans through the feeder.
• Please contact your local resellers for purchasing new Separation Roller.
notch
ArtixScan DI 7200S/7280S User's Manual
Flange
53