Briggs & Stratton ELITE Series Owner's Manual page 8

Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 8).Tighten by hand.
Figure 8 — Connect High Pressure Hose to Spray Gun
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
2. Attach other end of high pressure hose to high
pressure outlet on pump (Figure 9).Tighten by hand.
Figure 9 — Connect High Pressure Hose to Pump
2800 PSI Pressure Washer
3. Before connecting garden hose to water inlet, inspect
inlet screen (Figure 10). Clean screen if it contains debris
or replace if damaged. Refer to "O-Ring Maintenance"
section if inlet screen is damaged. DO NOT run pressure
washer if inlet screen is damaged.
Figure 10 — Connect Garden Hose to Water Inlet
4. Run water through your garden hose for 30 seconds
to clean out any debris.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 10).
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON water and squeeze trigger on gun to purge
pump system of air and impurities.
High pressure spray can cause paint chips or
other particles to become airborne.
• Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate eye protection.
8
Inspect inlet
screen, DO
NOT use if
damaged, clean
CAUTION
WARNING
if dirty.