Briggs & Stratton ELITE Series Owner's Manual page 7

3. Insert "L" bolt through hole just above billboard on
right side of handle (viewing from rear of unit). Hold
hook in place with pliers and tighten locknut with
7/16" wrench (Figure 3).
Figure 3 — Attach "L" Bolt to Handle
Attach Chemical Reservoirs
1. Use a 5/16" nut driver to attach chemical reservoir
assembly to handle with four black self tapping screws
in holes provided (Figure 4).
Figure 4 — Attach Chemical Reservoir Assembly to Handle
2. Attach chemical hose to chemical injection fitting on
pump (Figure 5).
Figure 5 — Attach Chemical Hose to Chemical Injection
Fitting on Pump
2800 PSI Pressure Washer
Assemble and Attach Hose Reel
1. Use a phillips screwdriver and 10mm wrench to attach
handle to reel with locknuts, flat washers, and bolts, as
shown in Figure 6. Note that bolts are inserted with
heads and washers inside hose reel.
Figure 6 — Attach Handle to Reel
Spray Gun
Hook
2. Use 5/16" nut driver to attach hose clip with black self
tapping screw in hole provided on clamp.
3. Use two 10 mm wrenches to secure hose reel to
handle with locknuts, clamps, and bolts, as shown in
Figure 7 (viewed from rear of unit).
Figure 7 — Install Hose Reel on Handle
Locknut
NOTE: There may be small tube adapters included with
the hose reel kit that is not used on this model.
IMPORTANT: You must take the hose off the reel when
operating your pressure washer.The reel is for hose
storage purposes only.
7
Hose reel
Flat washer
Bolt
Hose Clip
Screw
Handle
Locknut
Clamp
Bolt