Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required.
2
1
6c
6b
10
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection tank. (Fig. 3)
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on carton content list on page 5. (Fig. 4)
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws. (Fig. 5)
6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack into
the slot illustrated by the arrow, then pull the other end of the hose storage rack to align with the
corresponding arrow and insert into the slot until it is secured in place. (Fig. 6a - 6d)
7. Your vacuum comes ready for dry vacuum cleaning. For installation instructions, see page 10.
8. For wet vacuum cleaning, install the supplied foam wet filter. See page 11 for filter installation.
9. Place the power head back on the collection tank, and secure into place using the 2 side
latches. (Fig. 7 & 8)
10. Insert the locking end of the hose into the port on the collection tank and turn to lock into place.
(Fig. 9)
11. Choose the desired accessory and insert onto the end of the hose. (Fig. 10)
NOISE DIFFUSER
For quiet operation, install the noise diffuser into the blower port by inserting the locking end of the
diffuser into the blower port and turning clockwise to lock into place.
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
3
4
7
6d
6
5
8
eliminates the need for the three wire
6a
9
Advertisement
Table of Contents
