Table of Contents
Advertisement
5. Clean or replace the filters.
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place power head on collection tank and secure latches.
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter,
the motor will burn out and the warranty will be voided. Always keep spare filters on hand.
NOTICE! The filters included are made of high quality materials designed to stop small dust
particles. The cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will clog quickly and be very difficult to clean. Handle
the filter carefully when removing it for cleaning and replacing it. Check the filters for tears or small
holes, a small hole can let dust pass through and out of filter. Do not use a filter with holes or
tears; replace it immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.
Storage
1
2
Before storing your vac, the collection tank should be emptied and cleaned. The cord should be
wrapped and hung on the hook of the handle. The hose and accessories should be stored as
illustrated above (Fig. 1-3) so they can be readily available when needed. Store vac indoors.
INSTALLING & CLEANING CARTRIDGE FILTER
1
2
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the power head.
Carefully push filter in until it stops against the power head. (Fig. 2 & 3)
4. Place filter retainer on top of cartridge filter over the raised lip and tighten down by turning
retainer clockwise; do not over-tighten. (Fig. 4 & 5)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (Fig. 6)
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new filter is recommended.
3
3
4
10
5
6
Advertisement
Table of Contents
