Table of Contents
Advertisement
4. Install cleaned or new filter as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter
cage.
IMPORTANT! Clean or change the cartridge filter regularly for best performance.
ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the
cartridge filter, the motor will burn out and the warranty will be voided. Always keep spare filters on
hand.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
INSTALLING & CLEANING FOAM WET FILTER
1
2
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet. (Fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge
filter.
3. Carefully slide foam wet filter down over the filter cage making sure the cage is completely
covered. (Fig. 2 & 3)
4. Place the power head onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside down position, carefully remove foam wet filter. (Fig. 4)
2. Use a mild soap and water solution to wash foam wet filter and rinse with clean water. (Fig. 5)
3. Allow filter to air dry before installing and using again.
3
4
11
5
Advertisement
Table of Contents
