Replacing The Filter; Removing The Filter; Technical Data; Disposing Of The Appliance - DeLonghi ETAM29.62X Instructions For Use Manual

5. Insert the filter in the water tank and immerse it complete-
r
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 37).
6. Insert the filter in the filter housing (A21) (fig. 36) and
-
press as far as it will go.
7. Close the tank with the lid (A22) (fig. 38), then replace the
tank in the machine.
-
s
-
When you install the filter, you must notify the appliance of its
m
presence.
8. Press the
9. Press
2
on the display (B3).
10. Press the OK icon (B1) (fig. 4).
11. "Enable?" is displayed.
12. Press the OK icon to confirm the selection. "HOT WATER
Press OK" is displayed.
d
13. Place a container underneath the cappuccino maker (A8)
e
(min. capacity: 500ml) (fig. 5).
-
14. Press the OK icon to confirm the selection. The appliance
begins hot water delivery and the message "Please wait" is
displayed.
15. After the flow of hot water stops, the appliance automati-
cally resets to "Ready for coffee" status.
e
The filter is now active and you can use the coffee machine.

15.2 Replacing the filter

When "REPLACE FILTER" appears on the display (B3), after two
months (see date indicator) or when the appliance has not been
used for 3 weeks, you should replace the filter:
1. Extract the tank (A20) and exhausted filter (C4).
2. Take the new filter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section.
3. Place a container underneath the cappuccino maker (min.
capacity: 500ml).
4. Press the
5. Press
is displayed.
6. Press the OK icon (fig. 4).
7. The message "Confirm?" is displayed.
37
icon (B2) to enter the menu;
(B4) or (B5) until "Install filter" appears
icon (B2) to enter the menu;
(B4) or (B5) (fig. 7) until "Replace filter"
8. Press the OK icon to confirm the selection.
9. "HOT WATER Press OK" is displayed.
10. Press the OK icon to confirm the selection. The appliance
begins hot water delivery and the message "Please wait" is
displayed.
11. After the flow of hot water stops, the appliance automatically
resets to "Ready for coffee" status.
The new filter is now active and you can use the coffee machine.

15.3 Removing the filter

If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Remove the tank (A20), remove the filter (C4) and put the
tank back in the appliance.
2. Press the
3. Press (B4) or
38
Enabled" appears on the display (B3).
4. Press the OK icon (B1) (fig. 4).
5. "Disable?" appears on the display.
6. Press the OK icon to confirm and the
menu.

16. TECHNICAL DATA

Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Size LxDxH:
Cord length:
Weight:
Max. beans container capacity:
The appliance complies with the following EC
directives:
• European Standby Regulation 1275/2008
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.

17. DISPOSING OF THE APPLIANCE

The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
19
icon (B2) to enter the menu.
(B5) (fig. 7) until "Install filter,
icon to exit the
220-240 V~ 50/60 Hz max. 10A
1450W
1,5MPa (15 bar)
1,4 l
195x480x340 mm
1100 mm
9,3 kg
200 g