Displayed Messages - DeLonghi ETAM29.62X Instructions For Use Manual

18. DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A15) is full.
GROUND TOO FINE ADJUST
MILL
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A15) has
ADD PRE-GROUND COFFEE
DESCALE
LESS COFFEE
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
GENERAL ALARM
POSSIBLE CAUSE
Insufficient water in the tank (A20).
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
not been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser (A19) has not been replaced after
cleaning.
The inside of the appliance is very dirty.
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
Empty the grounds container and drip tray
(A14), clean and replace. Important: when
removing the drip tray, the grounds contain-
er must be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
Repeat coffee delivery and turn the grind-
ing adjustment dial (A23) (fig. 11) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section "9.4 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A20) is fully inserted.
Deliver a little water until the flow becomes
regular.
Remove the drip tray (A14) and insert the
grounds container.
Place pre-ground coffee in the funnel (A4) or
deselect the pre-ground function.
The descaling procedure described in section
"13. Descaling" needs to be performed.
Select a milder taste by pressing the
icon (B4) (fig. 8) or reduce the quantity of pre-
ground coffee.
Fill the beans container (A3) (fig. 12).
Empty the funnel with the help of the brush
(C5) as described in section "12.8 Cleaning the
pre-ground coffee funnel".
Insert the infuser as described in section ""12.9
Cleaning the infuser".
Clean the inside of the appliance thoroughly,
as described in section "13. Descaling". If the
message is still displayed after cleaning, con-
tact a service centre.
20