Table of Contents
Advertisement
Installed Indoor Electronics Module
Figure 17 displays the various wire routing and drops when the Electronics Module is
completely configured and installed.
All installation procedures are the same for the Indoor unit as they are for the Outdoor unit.
However, because the housing is not being utilized for indoor applications, wires and cables
are routed and secured differently. Refer to the figure above when routing and securing these
wires and cables.
61287722G1-5B
Ground
Figure 17. Completed Indoor Electronics Module
TOTAL ACCESS 373E
1287723G1
TELEPHONE TROUBLESHOOTING:
1. Identify the bad line (POTS 1-8).
2. Plug any working phone into
the appropriate jack.
If the telephone works, the unit
is functioning normally.
If the telephone does not work,
contact your service provider.
3. Remove the telephone from the
POTS jack.
Tie Wrap Point
Power
Installation
Tie Wrap Point
Tie Wrap Point
31
Advertisement
Table of Contents
Troubleshooting
