Program 32: Shutter Hold Mode - Camtraptions PIR Manual

Program 32: Shutter Hold Mode
Program 32 sends a single full-press signal to the camera. The press
length is extended if additional motion is detected during the press.
This program replicates the behaviour of the Version 1 Camtraptions
PIR Sensor.
Use the Time dial to set the minimum press duration. The minimum
duration can be varied from a few seconds (fully anticlockwise) to just
over 3 minutes (fully clockwise). If motion is detected during a press,
the press length is extended.
Use the Luminosity dial to select the minimum gap between presses
from 1s (fully anticlockwise) up to 60s (fully clockwise).
Camtraptions PIR Motion Sensor Manual Page 24