Table of Contents
Advertisement
Program 21 & 22: Fixed Duration, Day
Program 21 uses half-press commands
Program 22 uses full-press commands
These are Day Programs so it is possible to limit operation based on
the ambient light levels. The minimum gap between bursts is 5
seconds.
Use the Time dial to set the video length. Video length can be varied
from a few seconds (fully anticlockwise) to just over 3 minutes (fully
clockwise).
Use the Luminosity dial to select the light cut-off threshold; when fully
anticlockwise the camera will fire all of the time, otherwise the PIR will
only operate when the luminosity is greater than the threshold set. If
the dial were to be turned fully clockwise, the camera would only work
in very bright light.
Program 23 & 24: Minimum Duration, Day
Program 23 uses half-press commands
Program 24 uses full-press commands
These are Day Programs so it is possible to limit operation based on
the ambient light levels. The minimum gap between bursts is 5
seconds.
Use the Time dial to set the minimum video duration. The minimum
duration can be varied from a few seconds (fully anticlockwise) to just
over 3 minutes (fully clockwise). If motion is detected during a
recording, the video length is extended.
Use the Luminosity dial to select the light cut-off threshold; when fully
anticlockwise the camera will fire all of the time, otherwise the PIR will
only operate when the luminosity is greater than the threshold set. If
the dial were to be turned fully clockwise, the camera would only work
in very bright light.
Camtraptions PIR Motion Sensor Manual
Page 21
Advertisement
Table of Contents
