Programs 1 To 12: Interval; Program 1 To 6: Interval With No Luminosity Cut-Off; Program 7 To 9: Interval, Night - Camtraptions PIR Manual

Programs 1 to 12: Interval
These Programs are primarily for still photography. When motion is detected,
the camera will take a burst of photos.
Program 1 to 6: Interval with No Luminosity Cut-off
Program 1 will take 1 photo per detection
Program 2 will take 2 photos per detection
Program 3 will take 3 photos per detection
Program 4 will take 4 photos per detection
Program 5 will take 5 photos per detection
Program 6 will take 6 photos per detection
There is no luminosity cut-off in these programs so they will operate at
all times, regardless of the ambient light conditions.
Use the Time Dial to adjust the frequency of the shots from one shot
every 0.5s (fully anticlockwise) to one shot every 8s (fully clockwise).
Use the Luminosity dial to select the minimum gap between bursts
from 1s (fully anticlockwise) up to 60s (fully clockwise).
Program 7 to 9: Interval, Night
Program 7 will take 1 photo per detection
Program 8 will take 2 photos per detection
Program 9 will take 3 photos per detection
These are Night Programs so it is possible to limit operation based on
the ambient light levels. The minimum gap between bursts is 5
seconds.
Use the Time dial to adjust the frequency of the shots from one shot
every 0.5s (fully anticlockwise) to one shot every 8s (fully clockwise).
Use the Luminosity dial to select the light cut-off threshold; when fully
clockwise the camera will fire all of the time, otherwise the PIR will only
operate when the luminosity is lower than the threshold set. If the dial
were to be turned fully anticlockwise, the camera would only work in
complete darkness.
Camtraptions PIR Motion Sensor Manual Page 17