Program 29 & 30: Wake Then Shoot; Program 31: Wake Only - Camtraptions PIR Manual

Program 29 & 30: Wake then Shoot
Program 29: after the wake period, a 1s full-press signal is sent to the
camera.
Program 30: after the wake period, three shots are taken at 1 frame per
second.
These are Night Programs so it is possible to limit operation based on
the ambient light levels.
The period of time between waking the camera and the first shot firing
is set via the Time Dial. Wake time can be varied from 0.5s (fully
anticlockwise) to 8s (fully clockwise).
Use the Luminosity dial to select the light cut-off threshold; when fully
clockwise the camera will fire all of the time, otherwise the PIR will only
operate when the luminosity is lower than the threshold set. If the dial
were to be turned fully anticlockwise, the camera would only work in
complete darkness.
Program 31: Wake Only
Program 31 just sends a 2s half-press signal to the camera and no full-
press signal.
This program is intended for use in a dual sensor set-up in which the
one sensor wakes the camera and then a second sensor fires the
camera when the animal reaches a pre-determined position. The
sensors can be connected to the camera using a simple cable splitter
or wireless triggers.
This is a Night Program so it is possible to limit operation based on the
ambient light levels.
Time Dial is not used by this program.
Use the Luminosity Dial to select the light cut-off threshold; when fully
clockwise the camera will fire all of the time, otherwise the PIR will only
operate when the luminosity is lower than the threshold set. If the dial
were to be turned fully anticlockwise, the camera would only work in
complete darkness.
Camtraptions PIR Motion Sensor Manual Page 23