Table of Contents
Advertisement
Program 17 & 18: Fixed Duration, Night
Program 17 uses half-press commands
Program 18 uses full-press commands
These are Night Programs so it is possible to limit operation based on
the ambient light levels.
Use the Time dial to set the video length. Video length can be varied
from a few seconds (fully anticlockwise) to just over 3 minutes (fully
clockwise).
Use the Luminosity dial to select the light cut-off threshold; when fully
clockwise the camera will fire all of the time, otherwise the PIR will only
operate when the luminosity is lower than the threshold set. If the dial
were to be turned fully anticlockwise, the camera would only work in
complete darkness.
Program 19 & 20: Minimum Duration, Night
Program 19 uses half-press commands
Program 20 uses full-press commands
These are Night Programs so it is possible to limit operation based on
the ambient light levels.
Use the Time dial to set the minimum video duration. The minimum
duration can be varied from a few seconds (fully anticlockwise) to just
over 3 minutes (fully clockwise). If motion is detected during a
recording, the video length is extended.
Use the Luminosity dial to select the light cut-off threshold; when fully
clockwise the camera will fire all of the time, otherwise the PIR will only
operate when the luminosity is lower than the threshold set. If the dial
were to be turned fully anticlockwise, the camera would only work in
complete darkness.
Camtraptions PIR Motion Sensor Manual
Page 20
Advertisement
Table of Contents
