Table of Contents
Advertisement
Program 13 & 14: Fixed Duration with No Luminosity Cut-off
Program 13 uses half-press commands
Program 14 uses full-press commands
There is no luminosity cut-off in these programs so they will operate at
all times, regardless of the ambient light conditions.
Use the Time dial to set the video length. Video length can be varied
from a few seconds (fully anticlockwise) to just over 3 minutes (fully
clockwise).
Use the Luminosity dial to select the minimum gap between video
recordings from 1s (fully anticlockwise) up to 60s (fully clockwise).
Program 15 & 16: Minimum Duration with No Luminosity Cut-
off
Program 15 uses half-press commands
Program 16 uses full-press commands
There is no luminosity cut-off in these programs so they will operate at
all times, regardless of the ambient light conditions.
Use the Time dial to set the minimum video duration. The minimum
duration can be varied from a few seconds (fully anticlockwise) to just
over 3 minutes (fully clockwise). If motion is detected during a
recording, the video length is extended.
Use the Luminosity dial to select the length of the press that is used to
start recording. Set a short press duration for fast cameras that wake
up quickly. Set a long press duration for cameras that take longer to
wake and register commands. In general, the shortest possible press
length should be used as some cameras only commence recording
when the press is released. The other video programs all use an initial
press length of 3.5 seconds.
Camtraptions PIR Motion Sensor Manual
Page 19
Advertisement
Table of Contents
