Log Placement (Charisma) - Monessen Hearth Glow Getter Series Installation & Owner's Manual

WARNING
• Gloves are recommended when handling logs to
prevent skin irritation from loose fibers. Logs
are fragile - handle with care.
• Use only rock wool provided with log set.
• DO NOT ADD ADDITIONAL ROCK WOOL.
Wash hands after placing rock wool. Itching may occur.
NOTE: Installation instructions are the same for 18",
24" and 30" log sets. Pictures used in this instruction
illustrate the 24" set. Some variation may exist between
the images and the set included with the instructions.
B. Log Placement (Charisma CR18-H,
CR24-H, CR30-H)
1. Before installing logs, place rock wool in front of the
grate. Loosely apply nickel size pieces to allow the
gas to flow through for proper burn and not to be
obstructed. Failure to do so would cause a higher
level of CARBON MONOXIDE. See Figure 6.1.
Rock Wool
Figure 6.1 - Installing Rock Wool
2. Place log #1 on the right-hand side of the burner
assembly by positioning the pin locator hole on the
bottom of the log over the pin on the right-hand side
of the burner and by rotating the log clockwise toward
the back to contact the rear bend on the sheet metal
of the burner assembly. With the log in place, make
sure that the notch on the bottom of the log match up
with the bracket on the grate. See Figure 6.2.
Figure 6.2 - Log #1 Placement
1
Monessen • Glow Getter Owner's /Installation Manual • 4621-900 Rev. E • 09/20
3. Hold log #2 with the flat surface away from you.
Place log #2 toward the back to the left by positioning
the pin locator hole on the bottom of the log over the
pin on the left-hand side and push back against the
rear bend on the sheet metal of the burner assembly.
See Figure 6.3.
2
Figure 6.3 - Log #2 Placement
4. Hold log #3 with your left hand with the fat end away
from you. Place log # 3 by positioning the notch on
the bottom of the log over the left side of the grate
and rest the fat end onto log #2. See Figure 6.4.
3
Figure 6.4 - Log #3 Placement
5. Hold log #4 with the pointed end toward the left.
Place log #4 by positioning the pin locator hole on the
bottom of the log over the right pin behind the grate
and resting the right end of the log over the notch on
log #1. See Figure 6.5.
Figure 6.5 - Log #4 Placement
4
23