Table of Contents
Advertisement
LOG PLACEMENT
Before you begin: This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs
with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After
handling logs, wash your hands gently with soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of this
heater. Sooting and other problems may result if the logs are not properly
and firmly positioned in the appliance. Never add additional logs or
embellishments such as pine cones, vermiculite or rock wool to the heater.
Proper installation sequence:
1. Install the front/rear log (#1)
on the grate. Visually check
that the notch on the front
log rests securely on the
front grate fingers. In addi-
tion, the notches in the back
of the rear log should con-
tact the two tabs on the back
side of the grate.
2. Install the cross log (#2) by
engaging the holes in the
cross log onto pins on the
front/rear log.
Failure to position the parts in accordance with these diagrams or failure to use only
parts specifically approved with this heater may result in property damage or personal
injury.
Placing the decorative volcanic rock:
DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner. This
may cause sooting. Only place volcanic rock on the floor of the fireplace.
During initial operation of the new heater, burning logs will give off a paper burning
smell and orange flames will be present. Simply open the windows for a few hours to
vent the odor.
20
Charred Oak (DLY)
Figure 16: Proper Sequence of Log Installation
Burly Oak (GLY)
Hide quick links:
Advertisement
Table of Contents
