Rock Wool And Log Placement; Kentucky Stack - Monessen Hearth HVFL24 Installation And Operating Instructions Manual

ROCK WOOL
AND
Before you begin — This unit is supplied with four or five ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands
gently with soap and water to remove any traces of fibers.
The positioning of the logs are critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the logs and EB-RW (rock wool) supplied
with the unit.
Failure to position the parts in accordance with diagrams below or to use only
parts specifically approved for this heater may result in property damage or
personal injury.
PLACING ROCK WOOL
Starting on the second row of burner ports,
place EB-RW (Rock Wool) in dime-size pieces
on the second row of ports and going toward
back of front burner.
NOTE: Do not put EB-RW (Rock Wool) on first row of
burner ports.
• Use only EB-RW provided with log set.
• Do not add additional rock wool.
• Place EB-RW (rock wool) on front burner
ports only. DO NOT PLACE EB-RW ON
BACK BURNER!
INSTALLING KENTUCKY STACK LOGS ON GRATE
1. Install back log (#1) on two pins located near the back of
base. Check log position and stability. See Figure 26.
26
LOG PLACEMENT
.
Dime-Size
Rock Wool
Figure 25 - Placing Rock Wool
Pins
Figure 26 - Installing Back Log
First Row of Ports
(Leave Open)
Back Log #1
59D1015