Log Placement; Filling Front Buner Pan; Placement Of Glowing Embers (Rock Wool); Placement Of Decorative Volcanic Rock - Monessen Hearth VWF18NA Installation And Operating Instructions Manual

LOG PLACEMENT

FILLING THE BURNER PAN
Fill the burner pan with vermiculite to the bottom of the rear log and sloped to the front edge of the burner pan. Excess ver-
miculite can spill forward or to the side of the burner pan. Do not overfill the propane model. Do not cover the pilot (if SPK
or MVVK is installed) with vermiculite or rock wool (embers).

PLACEMENT OF GLOWING EMBERS (ROCK WOOL)

The Wildfire flame appearance can vary due to differences in draft and fireplace configurations and ember placement. After
installing rear (#1) and front logs (#2 and #3), cover the entire top surface of the vermiculite in the burner pan with the rock
wool supplied with unit. Tear the rock wool into pieces approximately 1 / " in size (roughly the size of a nickel) and cover
2
the burner evenly. Do no use more rock wool than the amount supplied with the unit. To enhance the appearance of the
Wildfire flame, it is recommended to form a mound of rock wool in the center of the burner, 2" to 3" high, visible through
the two front logs.

PLACEMENT OF DECORATIVE VOLCANIC ROCK

Sprinkle volcanic rock in front of front glowing embers and to both sides.
DO NOT SPRINKLE ON BURNERS, EMBER BED, PILOT OR LOGS.
IMPORTANT: Do not handle logs with your bare hands! Always wear gloves to prevent skin irritation
from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any
traces of fibers.
VWF18 MASSIVE OAK LOGS
1. S lide shield plate down back of burner pan. See Figure 17.
2. C enter rear log #1 on grate bars and flush with rear of the grate. See Figure 18.
Rear Log (#1)
Shield
Plate
Burner
Pan
Figure 17 - Sliding Shield Plate Down Back of Figure 18 - Centering Rear Log (#1) on Grate Bars
Burner Pan
Continued
14
27D7300