Nortel MER-1002-003 Manual page 25

Documentation Release Note
Nortel Networks
Note 1: Each Ring should now be in one of three States: None, Full or
Half. The Rings should NOT be in Survival state.
Note 2: All FIJI cards should be enabled.
13 Enable the Per Sig card.
LD 32
ENPS x (slot)
****
For example:
ENPS 12
ENPS 13
See Table 1, "Option 81 CNI group assignments," on page 6, Table 2,
"Option 81C CNI group default assignments (introduced with X11
25.xx)," on page 7 or Table 3, "Option 81C CNI group assignments on
a system that originated as a non-FNF system prior to X11 Release
25," on page 8 for slot and Group assignments.
14 Plug in the Conf/TDS cards. Push the latches forward to lock the card
in place.
15 Faceplate enable the Conf/TDS cards.
16 Enable the Conf/TDS cards.
LD 34
ENLX x (loop)
****
17 Add additional Network cards as required.
The upgrade procedure is complete. The FIJI Ring States should be in Half
mode. Verify that phone calls can be made in the new group.
—————————— End of Procedure ——————————
to load the program
to enable the Peripheral Signalling card
to exit the program
to enable slot 12 (Group 6)
to enable slot 13 (Group 6)
to load the program
to enable the Conf/TDS card
to exit the program
11/4/02
Number: MER-1002-003
25 of 26
TM