Nortel MER-1002-003 Manual page 14

Documentation Release Note
Nortel Networks
Note: Each end of the NTRC48 cable is labeled "Tx" or Rx" in the
factory.
Procedure 6
Labelling and routing the shelf 1 fiber optic cables (descending)
1 Start with Group 0, shelf 1.
2 Label each cable on both sides with the appropriate connection
information from Table 5.
3 Route a NTRC48 FIJI Fiber Ring cable of the appropriate length from
shelf 1 of the FIJI card in Group 0, to the FIJI card in the new highest
Network Group, shelf 1.
4 Route a NTRC48 cable from the FIJI card in the new highest Network
Group, shelf 1 to the FIJI card in the second highest Network Group,
shelf 1.
5 Continue to route NTRC48 FIJI Fiber Ring cables of the appropriate
lengths between shelf 1 of each new Network Group. Route these
cables in descending order of Network Groups.
6 Route a final cable to the current highest Network Group, shelf 1
—————————— End of Procedure ——————————
11/4/02
Number: MER-1002-003
.
14 of 26
TM