Changing The Battery; Chirp Indicators; Alarm Indicators; Parking Lights - Autopage RF-225 Operation Manual

ALARM INDICATORS

(OPTIONAL) If alarm options are installed.

CHIRP INDICATORS:

Chirp Function
1 chirp Arm
2 chirps Disarm
3 chirps Defective
reminder
4 chirps Disarm/
Intrusion
6 chirp Car
Locator
LED INDICATORS:
LED Function
Off Disarmed
Slow Armed
flash
Fast Passive
flash arming
On Valet mode
(solid)
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
operation.
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT-33:
The XT-33 transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are
sandwiched together with the (+) side facing upward. To replace the battery, you will need to
use a small flat blade screwdriver. Locate the small notch on the low er right side of the
transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case
from the bottom case. It should snap apart after breaking the seal. Before removing the
batteries note the direction of the positive (+) terminal. Place the new batteries in exactly the
same manner, being careful not to bend or damage the contact terminal. Snap the cases back
together and then test the transmitter to insure it arms and disarms the alarm.

PARKING LIGHTS:

Parking Light
1 flash
2 flashes
3 flashes
12 flashes
LED
2 Trigger on trunk/hood
flashes...
pause
3 Trigger on door switch
flashes...
pause
4 Trigger on Dual Zone
flashes... Shock Sensor
pause
5 Trigger
flashes... switch
pause
6
Function
Arm
Disarm
Disarm/
Intrusion
Car Locator
Function
on Ignition
undesired
(2) CR2016
3-Volt Batteries