Using Your Plug In Heater - Russell Hobbs RHPH7001 Manual

USING YOUR PLUG HEATER
2. Press the 'ON/OFF' button on side of the unit to "On" position.
The heater will turn on.
3. Press the 'Temp. +' button to increase the temperature setting
or press the 'Temp. –' button to decrease the temperature
4. To adjust the speed of the fan to high or low press the 'MODE'
button. The display will show LL for low mode and HH for high
mode
5. When finished, press the 'MODE' to the 'OFF' setting. The
heater will turn off immediately. However the fan may continue to
operate for approximately 1 minute to allow for the interior
components to cool. The fan will then turn off automatically. Turn
the power switch at the side of the heater to the 'OFF' position
and unplug heater from power outlet.
6. To set the timer function (0 – 12 hours) press and hold the
'MODE' button. The unit will be in the timer function and the
display will show 0. Press the timer button until you have set the
timer to the number of hours you want the heater to run for
before it will power itself off. The hour options for the timer are
from 0 to 12 hrs. (in 1 hr increment).
Note:
• The product will run continuously unless the timer has been
set or you turn off the power.
• When powering off the heater, the heater will stop the
heating process immediately. However the fan will continue
to operate for approximately 1 minute to allow for the interior
components to cool. The fan will then turn off automatically.