Using Your Plug In Heater - Russell Hobbs RHPH2001 Manual

USING YOUR PLUG IN HEATER

2. Press the 'ON/OFF' switch on side of the unit to "On" position.
The heater will turn on.
3. Press the ' ' button, the heater start running
4. Press the 'Temp. +' button to increase the temperature setting
or press the 'Temp. –' button to decrease the temperature
6. To adjust the speed of the fan to high or low press the 'Temp. –'
and 'Temp. +' buttons simultaneously. The display will show LL for
low mode and HH for high mode
7. To set the timer function (0 – 12 hours) press the 'Timer'
button. The display will show 0, press the timer button until you
have set the timer to the number of hours you want the heater to
run for before it will power itself off. The hour options for the
timer are from 0 to 12 hrs. (in 1 hr increment).
8. When finished, press the ' ' button and the heater will stop
the heating process immediately. However the fan will continue to
operate for approximately 1 minute to allow for the interior
components to cool. The fan will then turn off automatically. Turn
the power switch at the side of the heater to the 'OFF' position
and unplug heater from power outlet.
Note:
• The product will run continuously unless the timer has been
set or you turn off the power.
• When powering off the heater, the heater will stop the
heating process immediately. However the fan will continue
to operate for approximately 1 minute to allow for the interior
components to cool. The fan will then turn off automatically.
Page 10